	To install "Delta Dome Overtravel Monitor" or to update the software version: 

1.	Run the "Install.bat" file by double clicking on it.

	If installing for the first time, also do the following:


2.	Run (double click) the file named icalsetup.exe on the CDROM. Note,do this before
	connecting the USB cable. Follow the instructions on the screen to install the
	InstaCal program.


	Connect the USB cable between computer and interface box. Wait for the data-acquisition
	device to be detected by Windows and for the hardware to be installed. It is important
	to do this before starting InstaCal. If the Windows New Hardware Wizard opens, When
	asked "Can Windows connect to Windows Update to search for software?", select "No, not
	this time". On the next screen, select "Install the software automatically (Recommended)".

	Start the InstaCal program from the Measurement Computing folder in All Programs
	from the Windows start menu. The data-acquisition device will be automatically detected
	and added to the config file. The program can then be closed. Note, if a different USB
	data-acquisition interface box is used at any time, InstaCal will have to be run to
	change the config file.


	A folder called "Delta Dome" will be created on the C: hard drive

	The Delta dome Overtravel Monitor can be started by running the DD.exe file

	Sometimes the Windows security settings may prevent files from being installed. If you find there is no dd.exe file in the
	C:\Delta Dome folder you will need to copy this from the downloaded files location to the
	C:\Delta Dome folder.

	(A shortcut to the dd.exe file can be put on the desktop for convenience)

	The User's Manual will also be copied into the "Delta Dome" folder



If the Delta Dome Overtavel Monitor is to be used on the same computer as the Free Stroke Analyser (bodymaker alignment software) which has a USB interface box similar to the Delta Dome interface box, the following instructions will ensure that both will work:

With the Delta Dome interface box still connected, connect the Free Stroke Analyser interface box using another USB port. Run InstaCal and both 	interface boxes should be listed (the Free Stroke Analyser one being Board #1). InstCal can then be closed. In the Free stroke Analyser software
under "Options" change the board number to number 1. Note, you may need to update your version of InstaCal if using an older version.